Mould Replacement And Synchronous Adjustment Of Blister Packaging Machine
Jul 29, 2022
Replacement of blister board-mounted molds: When the packaging shape changes, that is, when the quantity, size, variety and specifications of the packaging plate change, the molds and corresponding parts need to be replaced. The general steps for replacing the mold and the corresponding parts are: turn off the heating switch, cut off the water and gas sources, and turn all the switch knobs to the "0" position; use the jog button to make each station open to a maximum value; The parts that need to be replaced shall be replaced after the device has cooled to room temperature; after the replacement, synchronous adjustment shall be made to make the machine run for a short time, and the reciprocating motion shall be checked, and the operation shall be stable and without impact.
The parts and components that need to be replaced in the blister board loading machine: When the type and quantity of the packaged objects change, but the size of the packaging block remains unchanged, only the forming mold and feeding device are replaced: when the size of the packaging block changes, it must be completely replaced, that is, Forming dies, guide platforms, heat-sealing plates, punching devices, etc. all need to be replaced.
Synchronous adjustment of the blister plate loading machine: mainly to adjust the relative positions of the four stations of the forming device, the heat sealing device, the printing and creasing device, and the punching device, that is, the adjustment of the integer position of the blister plate on the film after forming , in order to ensure the accuracy of the punched plate size and the position of the blister relative to the plate.
IPv6 network supported 
Home
Products