The Problem Of The Splicing Table Of The Blister Packaging Machine

The splicing table of the blister packaging machine is the docking station for PVC.

At the same time, the splicing table has two cylinders to control the release and shutdown protection of the PVC.

When the clamping cylinder is released, the forming step is pulled; when the clamping cylinder clamps the PVC Then the forming traction reaches the end of the traction;

the third function of the splicing table is to adjust the stop bar to control the center position of the PVC when the waste edges on both sides of the PVC are asymmetrical.

The splicing station of the blister packaging machine is prone to two problems.

One is that the PVC is easy to run off or become thin during the forming step after each splicing.

This problem occurs because the edges of the butted PVC are uneven, or If the butt-joined transparent tape is not smoothly pasted, or the baffle of the splicing table is clamped too tightly, resulting in a slight change in the PVC, it will cause uneven stress on the PVC, and the heated PVC is easy to deform, which causes the PVC to run away.

Or the thinning is caused by the conflict between the splicing table stop bar and the PVC docking position, and the PVC changes drastically.

The first solution is to align the PVC each time the splices, and the transparent tape to be pasted must be flat and neat.

There is a lamination phenomenon during PVC molding. In this case, it is generally a waste of time and packaging materials for the empty board, and it is necessary to re-splice the pieces after the molding.

If the width between the splicing table of the blister packaging machine and the PVC is too large, it will cause the PVC to move left and right, and at the same time, it may cause the PVC to form an arc before the molding die due to the inertia of the traction, and the material PVC will leak due to uneven pressing. , There is a problem of poor molding.