What To Prepare Before Operating The Tablet Press
Sep 02, 2022
After the mold of the tablet press is installed, turn the steering wheel by hand to make the steering wheel turn 2-3 times, and observe the abnormal friction noise of the upper and lower impact rods on each track and each hole. Turn on the main power switch, the power indicator light is on, and the speed is 0. Press the vacuum cleaner start button, the vacuum cleaner running indicator lights up. Now test the air capacity in the vacuum cleaner. Turn on the light switch on the screen and turn on the pressed light.
In order to prevent the press from reaching the maximum speed immediately after starting, which may lead to negative overload of the tablet press, the necessary working speed must be determined before the press runs. Press this key, or you can set the speed of the turntable you want, then press the turntable key. At this point, the main engine kicks in and the dial spins and accelerates to the speed you set in 6 seconds. In addition, the speed measurement system consisting of the proximity switch and the tachometer has a sleep time, so it takes 3 seconds for the actual speed to be displayed on the tachometer. If any abnormality is found, press the stop button and the host will stop running immediately.
The fault alarm should make the frequency converter of the tablet press display the number of faults and the cause of the fault. It changes the effect of the engine. Therefore, after the problem is resolved, you should press the reset button and then press the console to start.
IPv6 network supported 
Home
Products